How to Replace a Nissan Juke Spare Key
Nissan Juke is a fun and stylish hatchback that features an unusual engine setup. It's noisy, but it's still enjoyable to drive.
The key fob battery on the Nissan Juke has to be replaced every two years or every two years, or when it's low. It is easy to do at home, but you'll need a few tools.
Dead Coin Battery
If your Nissan Juke key fob isn't working, the first thing to look at is the coin battery that is inside it. It could be dead and need to be replaced. This is a quick fix that will take only a few minutes. Flip the fob upside down and you'll be able access the tiny latch/release at the back. Remove the battery from the old one and then put in the new one, making sure that it is facing down on the fob. Line between the two halves of the fob in a careful manner.
The fob needs to be cleaned if it was exposed to water before you can install the new battery. This can be accomplished by using a paper towel and isopropyl alcohol or electronic cleaner, and then allowing it to dry completely prior to re-inserting the battery.
The key fob has to be paired with the car to start it. This can be accomplished by following the instructions in the owner's manual or an OBDII scanner. If the key fob hasn't been paired, this is the most likely cause of the reason it stopped working. It is also possible that the fob has an issue with the chip, but this is extremely rare. In this scenario the need for a new receiver module could be required. If this is the situation the receiver module will need to be replaced by a skilled technician.
Water Damage
Key fobs are powered by batteries, and the batteries should be replaced every two years, or at the point that the car ceases to respond when you push the "start" switch. The rubber seals on keys keep water out, but submerging a key fob into ocean or pool water can harm the chip's electronic. If this is the case you'll need an alternate key from Nissan or a locksmith.
If the key's fob has a working chip, it's likely that the computer has simply lost connection to it, which can happen for any number of reasons. This can be corrected by restarting the car. If the "Key ID error" message is still visible it is necessary to contact Nissan for assistance.
The three most common causes of this problem are dead battery on the key fob and keys that are not programmed and a damaged or faulty key fob that is damaged or faulty. The first two issues are easy to fix, and the third is harder to diagnose and repair on the spot, however it is generally fixable with a bit of patience. WhoCanFixMyCar allows you to compare Nissan Key Replacement costs in your area and schedule your repair. You can read reviews of local Nissan dealerships, Nissan mechanics, and garages in only a few moments.
Faulty Chip
The key fob on your Nissan Juke contains a special chip which sends a message to the vehicle every time you turn it. The key could stop working if the chip is faulty. If this happens, the problem is only solved by replacing the key. There are a variety of reasons your Nissan Juke's key may be damaged, including water damage or a dead battery for your coin or a damaged receiver module.
If your key fob stops working after a soak in the wash or even a bath, it is important to examine the chip for damage from water. Check that the clips that hold it in place are secure and that the chip is not exposed to water. If nissan qashqai key replacement uk notice any indications of water damage, consider removing the battery and cleaning the electronic component using isopropyl alcohol or electronic cleaner.
If the chip is damaged If the chip is defective, you must visit your local locksmith or dealer. They will need to know the year model, make, and year of your vehicle to locate a replacement. You will also need to note down the VIN (Vehicle Identification Number) to ensure that the dealer or locksmith knows exactly which key you own. This will enable them to check the correct key code and ensure they are cutting the correct one.
Faulty Receiver Module
The key fob sends a radio frequency signal to your car that performs various functions. It can open the trunk while you rush to your car with groceries or start your car by pressing the button on the fob. It can also open your windows and turn the horn on in the event that you lock the keys inside your car.
If the key fob stops working, it could be an issue with the receiver module in the vehicle. The receiver modules are tuned so they can detect specific frequencies which correspond to the signals generated by Nissan key fobs. A faulty receiver module will prevent your car from responding to the signal received by the Nissan key fob.
It's always best to have an extra Nissan key fob in case your original key is lost or breaks. A spare key can be programmed by a locksmith or a dealership to work with your Nissan and can save you the anxiety of locking your keys in your vehicle or losing them.
If your Nissan Juke's key fob was exposed to rain or clean tap water, you can solve the problem by cleaning it using isopropyl or an electronic cleaner. If the chip is damaged you'll have to purchase an alternative keyfob that could be coded for your vehicle by a locksmith or dealer.